Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
172
1) Hold the base printedcircuit board by grabbing its handles, A and B,
and insert it into the rack all the way through, then engage it with the
backpanel connector.
2) Place the fan unit back into the previous location by following the
mounting procedure described in Section 2.5.3.
3) Attach the cables detached before, correctly.
4) Switch on the power, and make sure that the printedcircuit board
operates normally.
Handle A
Handle B, with a hook
on the lower side
Fig. 2.6.1 Base printedcircuit board handles
Mounting procedure

Leave a Reply

Your email address will not be published. Required fields are marked *