Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
174
CAUTION
1 The base printedcircuit board must be removed before the
PCB card can be dismounted and mounted. Observe the
CAUTIONS in Section 2.6.1.
2 Be careful not install the PCB card in an incorrect location.
Otherwise, the printedcircuit board may be damaged. See
Section 2.3.1 for where to install the PCB card.
3 The boot software is stored in the FROM on the CPU card.
When replacing the CPU card, make sure that the function
stored on the replacement CPU card is of the same version
as before or of a later version. Otherwise, it may be
inoperable. (The version of the system software has
nothing to do with the general version of the printedcircuit
board.)
4 The installed boot software varies depending on the type of
the CPU card. When replacing the CPU card, make sure
that the replacement CPU card is also a Power Mate i CPU
card. Note that the 16i/18i/21i CPU card cannot be used in
place of the Power Mate i CPU card.
2.6.2
Mounting and
Demounting Card
PCBS

Leave a Reply

Your email address will not be published. Required fields are marked *