Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
2. HARDWARE
175
1) Dismount the base printedcircuit board by following the
dismounting procedure described in Section 2.6.1.
2) Pull outward the claw of each of the four spacers used to secure the card
PCB, then release each latch. (See Fig. a.)
3) Extract the card PCB upward. (See Fig. b.)
Card PCB Card PCB
Card PCB
Card PCB
Fig. a Spacer
Spacer
Connector
Connector
Fig. b
Demounting a card PCB

Leave a Reply

Your email address will not be published. Required fields are marked *