Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
176
1) Check that the claw of each of the four spacers is latched outward, then
insert the card PCB into the connector. (See Fig. c.)
2) Push the claw of each spacer downward to secure the card PCB. (See
Fig. d.)
3) Mount the base printedcircuit board by following the mounting
procedure described in Section 2.6.1.
Card PCB
Card PCB
Card PCB
Card PCB
Fig. c Spacer
Spacer
Connector
Connector
Fig. d
Mounting a card PCB

Leave a Reply

Your email address will not be published. Required fields are marked *