Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
2. HARDWARE
181
(1)Dismounting the base printedcircuit board
Before mounting the DeviceNet board, dismount the base
printedcircuit board.
For how to dismount the base printedcircuit board, see Section 2.6.1.
CAUTION
The base printedcircuit board must be dismounted before
the DeviceNet board can be mounted. An attempt to mount
the DeviceNet board without dismounting the base
printedcircuit board causes the DeviceNet board to
interfere with the base printedcircuit board, which may
damage the board.
(2)Removing the DeviceNet connector terminal board
From the DeviceNet board, remove the interface connector terminal
board. Loosen the two screws as shown in the figure below, then
remove the board.
Screw
Fig. 2.6.5
(3)Mounting the DeviceNet board
After dismounting the base printedcircuit board, mount the
DeviceNet board.
For how to mount the DeviceNet board, see Section 2.6.4.
(4)Mounting the base printedcircuit board
After mounting the DeviceNet board, mount the base printedcircuit
board.
For how to mount the base printedcircuit board, see Section 2.6.1.
(5)Mounting the DeviceNet connector terminal board
On the DeviceNet board, mount the interface connector terminal
board. After mounting the board, secure the two screws on the
terminal board.
NOTE
The terminal board of this connector must be removed
before the base printedcircuit board can be mounted.
Mounting the DeviceNet
board

Leave a Reply

Your email address will not be published. Required fields are marked *