Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
192
The following applies to the 8.4 color LCD printedcircuit board used
in the detachable LCD/MDI type B.
Table 2.7.6(b) Specification of printedcircuit board for 8.4 color LCD
Name
Specification
Printedcircuit board for 8.4 color LCD A16B23000201
Replace the fuse FS1 while referring to the description of replacing the
fuse for 7.2 monochrome LCD in Subsection 2.7.3.
Table 2.7.6 (c) Capacity and specification of the fuse for the 8.4 color
LCD printedcircuit board
Name
Capacity Specification
FS1 5.0A A02B0200K103
Fuse FS1
This subsection applies to the LCD with touch panel.
Table 2.7.7(a) Specification of LCD with touch panel
Name
Specification
Color LCD with touch panel A02B0259C212
Monochrome LCD with touch panel A02B0259C211
There is a 24 VDC power supply input fuse (FUSE) on the LCD with
touch panel. If nothing appears on the screen when the 24 VDC power
supply to the LCD with touch panel is turned on, it is likely that the fuse
may have blown out. Take out the fuse, and check it for conduction with
a VOM meter or visually. If it turns out to have blown out, find and
remove the cause, and then replace the fuse.
Table 2.7.7 (b) Capacity and specification of the FSSB I/O module fuse
Name
Capacity Specification
FUSE 2.0A A02B0265K101
See Subsection 2.3.22 for the location of the fuse.
Fuse on the 8.4 color
LCD printedcircuit
board
2.7.7
Fuse for the LCD with
Touch Panel

Leave a Reply

Your email address will not be published. Required fields are marked *