Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
194
Table 2.7.9 (b) Capacity and specification of the fuse of the FSSB I/O
module
Name
Capacity Specification
FUSE1 1.0A A03B0815K001
LED 1
Fuse FUSE1
This section applies to the analog servo interface unit (basic unit).
There is no fuse on the expansion unit.
Table 2.7.10 (a) Analog servo interface unit drawing number
Name
Specification
Analog servo interface unit (basic unit) A02B0259C180
The analog servo interface unit contains a 24 VDC power input fuse,
FUSE1. If the LED1 does not light, the fuse may have blown. In such
a case, remove the fuse from its socket, then check its continuity using a
multimeter. When the fuse has blown, investigate the cause, take
appropriate action, then replace the fuse.
Table 2.7.10 (b) Analog servo interface unit drawing number
Name Capacity Specification
FUSE1 5.0A A02B0200K103
LED 1
Fuse FUSE1
2.7.10
Analog Servo Interface
Unit

Leave a Reply

Your email address will not be published. Required fields are marked *