Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
2. HARDWARE
209
This subsection applies to the replacement of the backlight of the color
LCD with touch panel.
Table 2.9.4(a) Specification of color LCD with touch panel
Name
Specification
Color LCD with touch panel A02B0259C212
The 10.4 color LCD backlight for the LCD with touch panel can be
replaced according to the following procedure.
Table 2.9.4(b) Specification of backlight
Spare part specification
Specification of backlight
A02B0236K116 A61L00010168#BL
(1)Turn off the power to the color LCD with touch panel, and wait for a
while.
(2)Remove the touch panel flexible cable from the color LCD with touch
panel and the backlight power supply cable connector. If it is hard to
remove them, previously remove the protection plate. (4 nuts)
(3)Remove the ornamental plate. (5 nuts)
(4)Remove the backlight power supply cable.
(5)Push the projection through the projection hole in the protection plate
to unlatch it, and then take out the backlight case.
(6)Replace the backlight inside the case with a new one.
(7)To assemble, reverse the above procedure. When mounting the unit
on the cabinet, run the backlight power supply cable on the inside of
the protection plate so that the cable will not be caught in between.
Nut for the ornamental plate
Nut for the ornamental plate
Projection hole
Flexible cable for
the touch panel
Backlight power
supply cable
Fig. 2.9.4(a) Rear view of the color LCD with touch panel (with the protection plate removed)
2.9.4
Replacing the
Backlight of the Color
LCD with Touch Panel

Leave a Reply

Your email address will not be published. Required fields are marked *