Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
210
Connector
Projection hole
LCD unit rear viewer
Projection
Backlight
Fig. 2.9.4(b) How to remove the backlight
This subsection applies to the replacement of the backlight of the
monochrome LCD with touch panel.
Table 2.9.5(a) Specification of monochrome LCD with touch panel
Name Specification
Monochrome LCD with touch panel A02B0259C211
The 9.5 monochrome LCD backlight for the monochrome LCD with
touch panel can be replaced according to the following procedure.
Table 2.9.5(b) Specification of backlight
Spare part specification Specification of backlight
A02B0236K114 A61L00010154#BL
(1)Turn off the power to the monochrome LCD with touch panel, and wait
for a while.
(2)Remove the touch panel flexible cable from the monochrome LCD
with touch panel and the backlight power supply cable connector. If
it is hard to remove them, previously remove the protection plate. (4
nuts)
(3)Remove the ornamental plate. (5 nuts)
(4)Remove the backlight power supply cable.
2.9.5
Replacing the
Backlight of
Monochrome LCD with
Touch Panel

Leave a Reply

Your email address will not be published. Required fields are marked *