Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
2. HARDWARE
217
By changing the setting (rotary switch) on an expansion module, a
connection can be made to skip an expansion module or expansion
modules as shown below.
Basic module
Basic module
Basic module
Basic module 1
Basic module 2
Basic module 3
Basic module 1
Basic module 1
Basic module 2
Basic module 2
Basic module 3
Basic module 3
When expansion module 1 is
skipped
When expansion module 2 is
skipped
When expansion modules 1 and
2 are skipped
Method of setting (control and setting method)
A control (rotary switch) is provided on the location shown below of each
expansion module. When changing the setting, turn the rotary switch
with a flatblade screwdriver with a tip diameter of about 2.5 mm.
Each setting position of the rotary switch has the meaning as indicated
below.
Setting
position
Indication Meaning of setting
0 0 Standard setting. The rotary switch is set to this
position at the time of shipment from FANUC.
1 Set the rotary switch of an expansion module to this
position when the one preceding expansion module
is skipped.
2.10
SETTING OF I/O
MODULE FOR
CONNECTOR PANEL

Leave a Reply

Your email address will not be published. Required fields are marked *