Fanuc Power Mate i-D/H Maintenance Manual

2. HARDWARE
B63175EN/03
218
Setting
position
Meaning of settingIndication
2 2 Set the rotary switch of an expansion module to this
position when the two preceding expansion mod-
ules are skipped.
3 Setting prohibited
4~F 4, , 6, ,
8, , A, ,
C, , E, ,
4, 8, or C has the effect of 0.
5, 9, or D has the effect of 1.
6, A, or E has the effect of 2.
7, B, or F has the effect of 3.
Examples of setting
Basic module
Basic module 1
Basic module 2
Basic module 3
Basic module
Basic module 1
Basic module 2
Basic module 3
Basic module
Basic module 1
Basic module 2
Basic module 3
(When expansion module 1 is skipped)
Set the rotary switch of expansion module 2
to setting position = 1. Do not change the
setting (setting position = 0) of expansion
module 3.
(When expansion module 1 and expansion
module 2 are skipped)
Set the rotary switch of expansion module 3
to setting position = 2.
(When expansion module 2 is skipped)
Set the rotary switch of expansion module 3
to setting position = 1. Do not change the
setting (setting position = 0) of expansion
module 1.
This function was not available initially, but was recently added. This
function became available, depending on the type of module, as indicated
below.
Expansion module B (DI/DO =
24/16, without a manual pulse
generator interface)
A03B0815C003 Available starting with shipment
in June 1998 and later
Expansion module C (DO = 16,
24A output)
A03B0815C004 Available starting with shipment
in August 1998 and later
Expansion module D (analog
input)
A03B0815C005 Available starting with shipment
in August 1998 and later

Leave a Reply

Your email address will not be published. Required fields are marked *