Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
3. INPUT AND OUTPUT OF DATA
233
3
INPUT AND OUTPUT OF DATA
Once the memory module or base printedcircuit board is replaced, or the
memory is cleared, it becomes necessary to reset data in the memory.
This chapter explains how to input parameters, part programs, and tool
offset amounts from an external I/O unit, such as a Handy File, and output
them to it.
3.1 SETTING PARAMETERS FOR
INPUT/OUTPUT 234. . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.2 INPUTTING/OUTPUTTING DATA 237. . . . . . . . . . . . .
3.3 DATA INPUT/OUTPUT ON THE
ALL IO SCREEN 250. . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.4 DATA INPUT/OUTPUT USING
A MEMORY CARD 270. . . . . . . . . . . . . . . . . . . . . . . . .
NOTE
The CRT/MDI operating instructions and related
information described in this chapter are applicable also to
the PDP/MDI, LCD/MDI, handy operators panel, and LCD
with touch panel.

Leave a Reply

Your email address will not be published. Required fields are marked *