Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
3. INPUT AND OUTPUT OF DATA
239
When output is conducted to the floppy, the program is output as the new
file after the files existing in the floppy. New files are to be written from
the beginning with making the old files invalid, use the above output
operation after the N0 head searching.
When P/S alarm (No.086) occurs during program output, the floppy is
restored to the condition before the output.
When program output is conducted after N1 to N9999 head searching, the
new file is output as the designated nth position. In this case, 1 to n1
files are effective, but the files after the old nth one are deleted. If an
alarm occurs during output, only the 1 to n1 files are restored.
To efficiently use the memory in the cassette or card, output the program
by setting parameter NFD (No.0101#7 or, No.0111#7) to 1. This
parameter makes the feed is not output, utilizing the memory efficiently.
Head searching with a file No. is necessary when a file output from the
CNC to the floppy is again input to the CNC memory or compared with
the content of the CNC memory. Therefore, immediately after a file is
output from the CNC to the floppy, record the file No. on the memo.
1. Select MDI mode.
2. Press
OFFSET
SETTING
key then soft key [SETTING] to select a setting screen.
3. Set the cursor to PARAMETER WRITE and input
1
and
INPUT
.
At this time, alarm 100 will be generated.
4. Press
SYSTEM
key and soft key [PMC].
5. Press soft key [PMCPRM] and soft key [KEEPRL]
6. Set the cursor to K17 (SB5) or K900 (SB6) and set the first bit to 1.
X X X X X X
1
X
INPUT
Where, mark x is a former value
Thus, data input/output screen has been selected.
7. Select EDIT mode.
8. Press soft key
then key .
9. Press soft key [I/O] and set the parameters on I/O.
Item selection cursor moves to the following item after data of an item
is set.
10.In CHANNEL NO item, input
1
INPUT
to select I/O channel 1.
Explanations
(Output to a floppy)
D File output location
D An alarm while a
program is output
D Outputting a program
after file heading
D Efficient use of memory
D On the memo record
3.2.3
Outputting PMC
Parameters
Procedure (CRT/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *