Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
3. INPUT AND OUTPUT OF DATA
247
1. Select the EDIT mode.
2. Turn off the program protect (KEY=1).
3. Press
PROG
key, and press soft key[PRGRM] to display the program
contents screen.
4. Press soft key [(OPRT)],
, [F SRH], and
5
[EXEC] to select
the tool compensation amount file.
5. Press
OFFSET
SETTING
key, and soft key [OFFSET] to display the tool
compensation amount screen.
6. Press soft key [(OPRT)] and
key.
7. Press [READ] key and [EXEC] key and data input is started.
1. Select the EDIT mode.
2. Display the data display screen by pressing [VAR] key.
3. Press [READ] key.
4. The input offset data will be displayed on the screen after completion
of input operation.
Confirm the following parameters. If 1 is set, set it to 0.
(Change it in MDI mode).
#7
3201
#6
NPE
#5 #4 #3 #2 #1
RAL
#0
NPE When programs are registered in part program storage area, M02,M30
and M99 are:
0 : regarded as the end of program.
l 1 : not regarded as the end of porgram.
RAL When programs are registered:
l 0 : All programs are registered.
1 : Only one program is registered.
#7
3202
#6 #5 #4
NE9
#3 #2 #1 #0
NE8
NE9 l 0 : Programs of 9000s can be edited.
1 : Programs of 9000s are protected.
3.2.13
Inputting Tool
Compensation Amount
Procedure (CRT/MDI)
Procedure (DPL/MDI)
3.2.14
Inputting Part Programs
CRT/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *