3. INPUT AND OUTPUT OF DATA
Inputting a program
1 Press soft key [PRGRM] on the ALL IO screen, described in Section
2 Select EDIT mode. A program directory is displayed.
3 Press soft key
[(OPRT)]. The screen and soft keys change as shown
⋅ A program directory is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
* * * * * * * * * * * *
F SRH READ PUNCH (OPRT)
PROGRAM (NUM.) MEMO
USED : 60
FREE : 2
O0010 O0001 O0003 O0002 O0555 O0999
O0062 O0004 O0005 O1111 O0969 O6666
O0021 O1234 O0588 O0020 O0040
4 To specify a program number to be assigned to an input program,
enter address O, followed by the desired program number.
If no program number is specified, the program number in the file or
on the NC tape is assigned as is.
5 Press soft key
[READ], then [EXEC].
The program is input with the program number specified in step 4
To cancel input, press soft key
To stop input prior to its completion, press soft key