Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
3. INPUT AND OUTPUT OF DATA
259
The ALL IO screen supports the display of a directory of floppy files, as
well as the input and output of floppy files.
Displaying a file directory
1 Press the rightmost soft key (continuous menu key) on the ALL
IO screen, described in Section 3.3.1.
2 Press soft key
[FLOPPY].
3 Select EDIT mode. The floppy screen is displayed.
4 Press soft key
[(OPRT)]. The screen and soft keys change as shown
below.
The floppy screen is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
READ/PUNCH (FLOPPY)
No. FILE NAME
O1234 N12345
(METER) VOL
EDIT
*
* * * * * * * * * * * *
12:34:56
F SRH READ PUNCH RENAMEDELETE
5 Press soft key [F SRH].
6 Enter the number of the desired file, then press soft key
[F SET].
7 Press soft key
[EXEC]. A directory is displayed, with the specified
file uppermost. Subsequent files in the directory can be displayed by
pressing the page key.
3.3.6
Inputting and
Outputting Floppy
Files
Procedure
EXECCANF SET

Leave a Reply

Your email address will not be published. Required fields are marked *