Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
3. INPUT AND OUTPUT OF DATA
261
Inputting a file
1 Press the rightmost soft key (continuous menu key) on the ALL
IO screen, described in Section 3.3.1.
2 Press soft key
[FLOPPY].
3 Select EDIT mode. The floppy screen is displayed.
4 The screen and soft keys change as shown below.
The floppy screen is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
READ/PUNCH (FLOPPY)
No. FILE NAME
O1234 N12345
(METER) VOL
EDIT
*
* * * * * * * * * * * *
12:34:56
F SRH READ PUNCH RENAMEDELETE
5 Press soft key [READ].
6 Enter the number of a file or program to be input.
Setting a file number: Enter the number of the desired file, then
press soft key
[F SET].
Setting a program number: Enter the number of the desired
program, then press soft key
[O SET].
7 Press soft key
[EXEC].
The specified file or program is read, and the INPUT indicator
blinks at the lowerright corner of the screen. Upon the completion of
input, the INPUT indicator is cleared from the screen.
Procedure
EXECCANF SET O SET STOP

Leave a Reply

Your email address will not be published. Required fields are marked *