Fanuc Power Mate i-D/H Maintenance Manual

3. INPUT AND OUTPUT OF DATA
B63175EN/03
262
Outputting a file
1 Press the rightmost soft key (continuous menu key) on the ALL
IO screen, described in Section 3.3.1.
2 Press soft key
[FLOPPY].
3 Select EDIT mode. The floppy screen is displayed.
4 The screen and soft keys change as shown below.
The floppy screen is displayed only in EDIT mode. In all other
modes, the ALL IO screen is displayed.
RENAME
O1234 N12345
(METER) VOL
READ/PUNCH (FLOPPY)
No. FILE NAME
EDIT
*
* * * * * * * * * * * *
12:34:56
F SRH READ PUNCH DELETE
5 Press soft key [PUNCH].
6 Enter the number of the program to be output, together with a desired
output file number.
Setting a file number: Enter the number of the desired file, then
press soft key
[F SET].
Setting a program number: Enter the number of the desired
program, then press soft key
[O SET].
7 Press soft key
[EXEC].
The specified program is output, and the OUTPUT indicator blinks
at the lowerright corner of the screen. Upon the completion of
output, the OUTPUT indicator is cleared from the screen.
If no file number is specified, the program is written at the end of the
currently registered files.
Procedure
EXECCANF SET O SET STOP

Leave a Reply

Your email address will not be published. Required fields are marked *