Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
3. INPUT AND OUTPUT OF DATA
265
Data held in SRAM memory of Power Mate i can be saved to a memory
card in MSDOS format.
Saving memory data
1 Press the rightmost soft key (continuous menu key) twice on the
ALL IO screen, described in Section 3.3.1.
2 Press soft key
[MCARD].
3 Place the Power Mate i in the emergency stop state.
4 Insert the memory card and press the soft key
[(Operation)]. The
following memory card status is displayed.
S 0 T0000
EDIT **** - - EMG- - 12: 15: 00
[FORMAT] [ SAVE ] [ ] [DELETE] [ ]
READ/PUNCH(MCARD) O1234 N12345
CNC RAM
256K byte 2. 000M byte S- RAM
File ( 1/ 1)
SRAM256A. FDB 262144 byte 97/ 01/ 23
Select : All data
Memory card
Message
5 Press soft key [SAVE].
6 A message prompting the user to confirm the operation is displayed.
Press soft key
[EXEC] to execute the save operation.
7 As the data is being saved to the card, the message RUNNING
blinks, and the number of bytes saved is displayed in the message
field.
8 Once all data has been saved to the card, the message
COMPLETED is displayed in the message field, with the message
PRESS RESET KEY. displayed on the second line.
9 Press the RESET key. The displayed messages are cleared from the
screen, and the display of the memory card state is replaced with that
of the saved file.
NOTE
All SRAM memory data of Power Mate i is saved to a
memory card. CNC memory data cannot be saved
selectively.
Saving memory data
Procedure
EXECCAN

Leave a Reply

Your email address will not be published. Required fields are marked *