Fanuc Power Mate i-D/H Maintenance Manual

3. INPUT AND OUTPUT OF DATA
B63175EN/03
268
The file name used for save operation is determined by the amount of
SRAM mounted in the Power Mate i. A file holding saved data is divided
into blocks of 512KB.
SRAM file
Amount of SRAM 256KB 1.0MB
Number of files 1
2
SRAM256A. FDB SRAM1_0A. FDB
SRAM1_0B. FDB
Message Description
INSERT MEMORY CARD. No memory card is inserted.
UNUSABLE MEMORY CARD The memory card does not contain device
information.
FORMAT MEMORY CARD. The memory card is not formatted. Format the
memory card before use.
THE FILE IS UNUSABLE. The format or extension of the file to be loaded
is invalid. Alternatively, the data stored on the
memory card does not match the SRAM
memory size of Power Mate i.
REPLACE MEMORY CARD. Replace the memory card.
FILE SYSTEM ERROR VVV An error occurred during file system
processing. VVV represents a file system
error code.
SET EMERGENCY STOP
STATE.
Save operation is enabled in the emergency
stop state only.
WRITEPROTECTED Save operation: The protect switch of the
memory card is set to the
disabled position.
VOLTAGE DECREASED. The battery voltage of the memory card has
dropped. (The battery requires replacement.)
DEVICE IS BUSY. Another user is using the memory card.
Alternatively, the device cannot be accessed
because automatic operation is in progress.
SRAM ³ MEMORY CARD? This message prompts the user to confirm the
start of data saving.
DO YOU WANT TO DELETE
FILE(S)?
This message prompts the user to confirm the
start of deletion.
DO YOU WANT TO
PERFORM FORMATTING?
This message prompts the user to confirm the
start of formatting.
SAVING Saving is currently being performed.
DELETING File deletion is currently being performed.
FORMATTING Memory card formatting is currently being
performed.
COMPLETED Save processing has been completed.
PRESS RESET KEY. Press the RESET key.
TURN OFF POWER. Turn the power off, then back on again.
File name and messages
D File name
Messages

Leave a Reply

Your email address will not be published. Required fields are marked *