Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
280
4
INTERFACE BETWEEN NC AND PMC
This chapter describes the signals between the machine operators panel,
magnetics cabinet and the PMC, connection of the signals between PMC
and CNC, and confirmation method of on/off state of these signals.
It also describes system configuration of PMC, parameters of PMC,
ladder and how to display time chart of the signals on the screen.
It also describes a method of inputting/outputting PMC parameters to an
external device.
4.1 GENERAL OF INTERFACE 281. . . . . . . . . . . . . . . . . .
4.2 SPECIFICATION OF PMC 282. . . . . . . . . . . . . . . . . . . .
4.3 PMC SCREEN (CRT/MDI) 288. . . . . . . . . . . . . . . . . . . .
4.4 OPERATION ON THE DPL/MDI 306. . . . . . . . . . . . . . .
4.5 ONLINE DEBUGGING FUNCTION 320. . . . . . . . . . .
4.6 LIST OF SIGNALS BY EACH MODE 322. . . . . . . . . .
4.7 ADDRESS LIST 324. . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.8 SIGNAL SUMMARY
(IN ORDER OF FUNCTIONS) 344. . . . . . . . . . . . . . . . .
NOTE
The CRT/MDI operating instructions and related
information described in this chapter are applicable also to
the PDP/MDI, LCD/MDI, handy operators panel, and LCD
with touch panel except:
Some operations are unavailable on the handy operators
panel, and the operating procedure for the LCD with touch
panel is different in part.

Leave a Reply

Your email address will not be published. Required fields are marked *