Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
4. INTERFACE BETWEEN NC AND PMC
289
Press soft key [PMCLAD], and a sequence program is displayed
dynamically and operation monitoring can be confirmed :
This screen can not be displayed with the handy operators panel.
LADDER NET 00010004
LOG1
TOP
BOTTOM SRCH
Number of net displayed
Comment
MONIT RUN
LOG1
LOG1
X000.4 *ESP
PORD POR
END1
ALWAYS1
EMERGENCY
POWER ON
STOP
RESET
WSRCH NSRCH
Ladder display
FSCRH ADRESS
Other soft keys
SYMBOL
Switched each
time pressed
RUN/STOP status
1. Low brightness display Contacts : open Relay : off
2. High brightness display Contacts : closed Relay : on
1. Use the cursor keys
or the page keys
PAGE
PAGE
to change
display positions.
2. [TOP]:Searches top of ladder.
3. [BOTTOM]:Search bottom of ladder.
4. Address.bit,[SRCH] or Signal name, [SRCH]
5. Address.bit,[WSRCH] or Signal name ,[WSRCH]
6. Net no.[NSRCH]:Ladder is displayed from the specified net.
7. Functional instruction no. [FSRCH] or Functional instruction
name[FSRCH]
8. [ADRESS]:Signal is displayed by address and bit no.
9. [SYMBOL]:Signal is displayed by signal name (symbol).
(If symbol is not registered at program preparation time, the address
of the signal is displayed).
4.3.2
PMCLAD Screen
D Contents displayed
D Search method

Leave a Reply

Your email address will not be published. Required fields are marked *