Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
290
[Remarks]
The search function searches a signal in the forward direction and
displays the ladder with the searched signal at its head. Because there
may exist plural contacts, repeat the search operation to find plural
locations, repeat the search operation to find plural locations with the
specified signal.
If a specified signal is not found up to the end of the program (ladder),
execution returns to the head of a program and search continues.
Ladder diagram and signal status dump can displayed together.
The dump is displayed over 2 lines at the last line of ladder diagram by
pressing the [DUMP] soft key.
PAGE
PAGE
keys or [SEARCH] soft key is used for changing of PMC
address.
The [DUMP] soft key has the follwing functions.
(1)[BYTE]: Byte type display (1 BYTE)
G0000 00 14 00 00 01 00 00 00 00 00 00 00 00 00 00 00
G0016 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
(2)[WORD] : Word type display (2 BYTE)
G0000 1400 0000 0001 0000 0000 0000 0000 0000
G0016 0000 0000 0000 0000 0000 0000 0000 0000
(3)[D.WORD]: Long word type display (4 BYTE)
G0000 00001400 00000001 00000000 00000000
G0016 00000000 00000000 00000000 00000000
The value of parameter of a functional instruction is displayed in the
functional instruction of a ladder diagram.
The function of the soft key is as follows:
(1)[DPARA] : The value of parameter is displayed in functional
instruction.
(2)[NDPARA] : The value of parameter is not displayed in functional
instruction.
The ladder display can be stopped by manual operation or trigger of
signal.
The former ladder diagram display renews signal status every moment.
But by using this function, all the ladder diagram at the specified moment
can be checked.
The stop conditions as a trigger are specified by rising or falling edge
detection of the designated signal.
D Dump display on ladder
diagram
D Parameter display on
ladder diagram
D Stop of ladder diagram
display by trigger of
signal

Leave a Reply

Your email address will not be published. Required fields are marked *