Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
292
This function is used for displaying the divided screen. It can display
max. six division.
For this operation, depress [WINDOW] soft key to bring the following
menu.
SEARCH ADRESS TRIGER WINDOW
DIVIDE CANCEL DELETE SELECT WIDTH
RET
The function of the soft key [WINDOW] is as follows:
(1)[DIVIDE] : The screen will be divided.
The dividing display of ladder diagram can be
displayed for the designated NET number.
(NET number+[DIVIDE])
(2)[CANCEL] : The dividing display of ladder diagram display ends.
(The screen returns to normal display.)
(3)[DELETE] : The screen division subject to operation is ended.
(4)[SELECT] : Change the screen subject to division operation.
(5)[WIDTH] : Change the width of division by using [EXPAND] or
[SHRINK] soft key.
(6)[EXPAND] : The divided screen is expanded.
(7)[SHRINK] : The divided screen is shrank.
When bit 1 in the keep relay K17 (SB5) or K900 (SB6) is 1, this function
is available and [ONLEDT] soft key is displayed.
When the ladder program is executing, a part of the ladder program can
be changed.
S Change the type of contact (A contact, B contact)
S Change address of contact and coil.
S Change address parameter of functional instruction.
This function dont change the size.
(Cannot be Addition, deletion and chanegable data size)
When bit 3 in the keep relay K18 (SB5) or K901 (SB6) is 1, this program
is automatically transferred to backup RAM after online edit.
When bit 3 in the keep relay K18 (SB5) or K901 (SB6) is 0, transfer to
backup RAM with COPY function of I/O screen. If power is off without
this operation, edited data is lost.
D Divided display of ladder
diagram
D ONLINE EDIT

Leave a Reply

Your email address will not be published. Required fields are marked *