Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
4. INTERFACE BETWEEN NC AND PMC
299
NOTE
CONDITION 1 and 2 are valid when TRIGGER ADDRESS
is set.
(d)Set a trigger mode
0 : Record signal status after the trigger condition is satisfied
1 : Record signal status before and after the trigger condition is
satisfied.
2 : Record signal status before the trigger condition is satisfied.
3 : Record signal status when the trigger condition is satisfied.
(Display is same as trace memory).
NOTE
TRIGGER MODE 1 and 2 are valid when CONDITION 1 or
2 is set.
2 Parameter setting screen (2nd page)
PMC SIGNAL ANALYSIS(PARAM)
SCOPE
MONIT RUN
Up to 16
signals
DELETE
1 : X0000.0 9 : Y0000.0
2 : X0000.1 10 : R0000.1
3 : X0002.0 11 :
4 : X0005.0 12 :
5 : 13 :
6 : 14 :
7 : 15 :
8 : 16 :
SIGNAL ADDRESS
INIT ADDRESS
a. Soft key [SCOPE]:Select signal waveform display screen
b. Soft key [DELETE] :Delete data on the cursor position
c. Soft key [INIT] :Initialize parameters of signal waveform display
d. Soft key [ADDRESS] or [SYMBOL]:Switch addresses and
symbols for display

Leave a Reply

Your email address will not be published. Required fields are marked *