Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
300
3 SCOPE screen
PMC SIGNAL ANALYSIS(PARAM)
SGNPRM
START
MONIT RUN
SAMPLING TIME : 10 CONDITION : 1
TRIGGER ADDRESS : G0007.2 TRIGGER MODE : 0
T.SRCH ADDRESS
X0000.0
X0000.1
X0002.0
X0005.0
+–––––––––+–––––––––+–––––––––+––––––
+–––––––––+–––––––––+–––––––––+––––––
0 256(MSEC)
J and “–” are used for display.
a. Soft key [SGNPRM] : Returns to parameter screen.
b. Soft key [START] or [STOP] :Start or stop the record.
(If TRIGGER MODE=3, signal is displayed when you press STOP
key.)
c. Soft key [T.SRCH] :Displayed for a specified time.
d. Soft key [ADDRESS] or [SYMBOL]:Switch addresses and
symbols for display
e. Soft key [EXCHG] : Change order of signals displayed.
·Press soft key [EXCHG]
·Move the cursor to a signal to be changed.
·Press soft key [SELECT].
·Move the cursor to the destination.
·Press [TO] and [EXEC], then the signal changes its order.
f. Soft key [SCALE]: Changes time scale for display. Scale changes
from 256 to 512, and to 1024 msec every time you press the key.
g. Cursor key
: Scrolls time axis forward and backward

Leave a Reply

Your email address will not be published. Required fields are marked *