Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
304
#7
K018
#6 #5 #4 #3 #2 #1 #0
CHKPRTY 0 : The parity check is performed for the system ROM and program
ROM/RAM.
1 : The parity check is not performed for the system ROM and program
ROM/RAM.
CALCPRTY 0 : The builtin programmer function performs RAM parity calculation.
1 : The builtin programmer function does not perform RAM parity
calculation.
TRNSRAM 0 : A ladder program is not automatically sent to the FROM after online
editing is completed.
1 : A ladder program is automatically sent to the FROM after online
editing is completed.
TRGSTAT 0 : The trigger stop function does not automatically start when the power
is turned on.
1 : The trigger stop function automatically starts when the power is
turned on.
These bits are status of not used for PMC management software are used
by system. Do not change the values.
Usually all the bits are 0.
1 Data setting screen
PMC DATA TBL CONTROL #001
G.DATA
G.CONT NO.SRH
MONIT RUN
INIT
No. of screen
NO. ADDRESS PARAMETER TYPE NO.OF DATA
001 D0000 00000000 0 10
002 D0020 00000011 1 20
003
004
005
006
007
008
No. of
data table
groups
No. of
data table
GROUP TABLE COUNT = 2
Group no. of
data table
Data table
head ad-
dress
Data length
Table
parameter
a. Soft key [G.DATA] : Select data display screen of data table.
(Next screen)
b.
NO. OF GROUPS [G.CONT]: Set the no. of groups of data table.
c.
Group No. [NO.SRH]:Move the cursor to a specified group.
d. Soft key [INIT]: Initializes the setting of data table.
No. of groups is 1, ADDRESS is D0000, PARAMETER is 0000000,
TYPE is 0, NO. OF DATA is 3000 (SB5) or 8000 (SB6).
D DATA TABLE screen

Leave a Reply

Your email address will not be published. Required fields are marked *