Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
4. INTERFACE BETWEEN NC AND PMC
307
The screen configuration for the PMC programmer (DPL/MDI) function
is as follows:
PMC programmer menu
PMC PRG MENU 1/4
>RUN/STOP
PMC PRG MENU 2/4
>EDIT
PMC PRG MENU 3/4
>SYSTEM PARAM
PMC PRG MENU 4/4
>I/O
Sequence program start and stop
LADDER RUN/STOP
MONITOR(STOP)
PMC editing menu
PMC EDIT 1/1
>LADDER
Setting and displaying PMC system parameters
CTR TYPE=BCD
(BINARY=0/BCD=1)
Screen for storing the sequence program into flash ROM
DEVICE=FROM
>WRITE Y/N[YES]
Editing ladder
mnemonics
N0001
RD X0000.0
or
or
or
or
or
or
or
or
or
or
INPUT READ
CAN
WRITE
INPUT
CAN
READ
WRITE
INPUT
CAN
READ
WRITE
INPUT
CAN
READ
WRITE
INPUT
CAN
READ
WRITE

Leave a Reply

Your email address will not be published. Required fields are marked *