Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
310
Selecting EDIT on the PMC programmer menu displays the editing
menu.
1. Display the PMC programmer menu.
2. Display the EDIT item by pressing the [ ] or [ ] key.
PMC PRG MENU 2/4
>EDIT
3. Press the [INPUT] or [READ] key. The PMC editing menu appears.
PMC EDIT 1/1
>LADDER
4. To end editing and display the PMC programmer menu, press the
[CAN] or [WRITE] key.
(1)Starting ladder mnemonics editing
Selecting LADDER on the PMC programmer menu displays the
ladder mnemonics editing screen. If the sequence program is running,
selecting this function automatically stops the program.
1 Display the PMC programmer menu.
2 Display the LADDER item by pressing the [ ] or [ ] key.
PMC EDIT 1/1
>LADDER
3 Press the [INPUT] or [READ] key.
When the ladder password protection is performed
go to 4
When the ladder password protection is not performed
go to 6
4 When the password protection is performed, message requiring the
release of password is displayed.
PASSWORD (R/W)
NOTE
A ladder program for which the password has been
specified cannot be edited by ladder mnemonics editing
until correct password is entered. Once password
protection is released, the protection remains released until
the power is turned off then on again.
4.4.3
Editing Sequence
Program (EDIT)
4.4.4
Editing Ladder
Mnemonics

Leave a Reply

Your email address will not be published. Required fields are marked *