Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
4. INTERFACE BETWEEN NC AND PMC
313
N1234
OR Y0032.4
After change
NOTE
If changing the instruction causes the memory capacity to
be exceeded, the [ALTER] key is ignored without changing
the instruction.
2 Deleting an instruction
(a) Display the instruction to be deleted.
(b)Press the [DELET] key.
The instruction is deleted and the next instruction is displayed.
3 Inserting an instruction
(a) Display the instruction after which an instruction is to be
inserted.
(b)Enter the instruction to be inserted.
(c) Press the [INSRT] key.
(Example) [AND], [STK], [INSRT]
N1234
AND R0123.4
Before insertion
N1234
AND.STK
After insertion
NOTE
If inserting the instruction causes the memory capacity to be
exceeded, the [INSRT] key is ignored without inserting the
instruction.
4 Deleting the ladder program
(a) Enter [ ], [9], [9], [9], [9].
(b)Press the [DELET] key.
The whole ladder program is deleted.
(4)Ending ladder mnemonics editing
1 Press the [CAN] or [WRITE] key.
2 EXECUTING is displayed.
N1234
AND.STK
3 The PMC editing menu appears.

Leave a Reply

Your email address will not be published. Required fields are marked *