Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
314
NOTE
1 When K19#0(SB5) or K902#0(SB6) of the keep relay area
for PMC parameter is set to 1, the screen for storing the
sequence program into FROM is displayed after ladder
editing.
Please refer to the Subsec. 4.4.7 and storing the sequence
program into FROM.
2 If the sequence program contains an error, the PMC editing
menu is not displayed but an error message appears on the
screen.
(Example) Error message
3 When parameter is multiple use error, the error message is
displayed on the screen.
(Example) Error message
Pressing the [ ] or [ ] cursor key displays the ladder
mnemonics editing screen.
4 Pressing the [POS], [PRGRM], [VAR], [DGNOS/PARAM]
or [ALARM] key during the editing of the sequence program
displays the CNC screen by forcibly terminating editing
even if the program contains an error.
DEVICE=FROM
>WRITE Y/N[YES]
END FUNCTION
MISSING
FUNC. PARAM NO.
DUPLICATE
Selecting RUN/STOP on the PMC programmer menu displays the
sequence program start/stop screen.
1 Display the PMC programmer menu.
2 Display the RUN/STOP item by pressing the [ ] or [ ] key.
PMC PRG MENU 1/4
>RUN/STOP
3 Press the [INPUT] or [READ] key. The sequence program start/stop
screen appears.
LADDER RUN/STOP
MONITOR [RUN]
4.4.5
Starting and Stopping
the Sequence Program
(RUN/STOP)

Leave a Reply

Your email address will not be published. Required fields are marked *