Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
316
NOTE
Use a memory card for ladder diagram editing or the
CONDENSE function of FAPT LADDER (for personal
computers). These methods may, however, not be effective.
Selecting I/O on the PMC programmer menu displays the screen for
storing the sequence program into FROM.
1. Display the PMC programmer menu.
2. Display the I/O item by pressing the [ ] or [ ] key.
PMC PRG MENU 4/4
>I/O
3. Press the [INPUT] or [WRITE] key. The sequence program storage
screen appears. Pressing the [ ] or [ ] key switches display between
[YES] and [NO].
DEVICE =FROM
>WRITE Y/N[YES]
DEVICE =FROM
>WRITE Y/N[NO]
4. When [NO] is displayed, pressing the [INPUT] key displays the
sequence program storage screen. When [YES] is displayed, pressing
the [INPUT] key starts writing the sequence program into flash
EEPROM.
EXECUTING is displayed during writing.
WRITE TO FROM
EXECUTING
EXECUTING blinks
Once the sequence program has been written normally,
COMPLETE is displayed.
WRITE TO FROM
COMPLETE
NOTE
If an error occurs, an error message appears on the screen.
Example error message
SIZE ERROR
4.4.7
Storing the Sequence
Program into Flash
EEPROM (I/O)

Leave a Reply

Your email address will not be published. Required fields are marked *