Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
4. INTERFACE BETWEEN NC AND PMC
321
D Setting by the rotary switch on Power Mate i equipment.
The detail of the setting method is referring to the chapter F.4.2.
The first selection mode is 3
The second selection mode is
0 : Cancel of the selection of the RS232C port by the second selection.
1 : Use the DPL/MDI Operation Package on the RS232C port 2
(Channel 2).
2 : Use the FAPT LADDR II on the RS232C port 2 (Channel 2).
When one of the following conditions is met, the online monitor driver
is started.
D Parameter RS232C is USE
D Setting of parameter No.0024 is 1 or 2
D The selection of the first selection mode is set to 3 and the second
selection mode is set to 2 by Power Matei equipment(Rotary
switch).
However if the selection is done by the method of Power Mate i
equipment (Rotary switch), the other setting method( Parameter
RS232C is USE or Setting of parameter No.0024 is 1 or 2) is
not effective.
The selection by Parameter screen for online monitor or parameter
No.0024 can be used when the setting by Power Mate i equipment (Rotary
switch) is cleared (first selection mode is set to 3 and the second
selection mode is set to 0).
NOTE
1 The online monitor driver occupies the line while it is
operating.
In this state, other input/output functions cannot use the
line.
If other input/output functions use the line, it is necessary to
display the abovementioned parameter and stop the
online monitor driver.
2 While the online monitor driver is operating, the following
functions cannot be used.
D [PMCLAD], [I/O], [EDIT], [SYSPRM] on CRT/MDI
D [EDIT], [SYSTEM PARAM], [I/O] on DPL/MDI
3 In case of operating NC, the screen display of NC (Position,
etc.) might be slow when using input/output functions (Load
from PMC, Store to PMC, etc.).
There is no problem in the operation of NC. It is
recommended to using input/output functions while NC is
not operating.
4 When the screen made by C language executor is
displayed, the communication speed decreases. It is
recommended to use input/output functions after moving to
other screens (Position, etc.).

Leave a Reply

Your email address will not be published. Required fields are marked *