Fanuc Power Mate i-D/H Maintenance Manual

4. INTERFACE BETWEEN NC AND PMC
B63175EN/03
344
f : Available
: Unavailable
Symbol Signal name Address PM iD PM iH
*+L1 to *+L8 G114 f f
*L1 to *L8
Overtravel signals
G116 f f
*ABSM Manual absolute signal G006#2 f f
X000#5 f
*DEC1
X1000#5 f
X002 f
*DEC1 to *DEC8 Reference position return deceleration signal
X1002 f
X001#5 f
*DEC2
X1001#5 f
*EAXSL
Control axis selection status signals
(PMC axis control)
F129#7 f f
*ESP G008#4 f f
*ESP
Emergency stop signal
X000#4 f f
*ESP X1000#4 f f
*
*ESPA Emergency stop signals (serial spindle) G071#1 f
*
*FLWU Followup signal G007#5 f f
*FV0 to *FV7 Feedrate override signals G012 f f
*FV0E to *FV7E Feedrate override signals (PMC axis control) G151 f f
*FV0O to *FV7O Software operators panel signals (*FV0 to *FV7) F078 f f
*HROV0 to *HROV6 1% step rapid traverse override signals G096#0 to #6 f f
*IT Interlock signal for all axes G008#0 f f
*IT1 to *IT8 Interlock signal for each axis G130 f f
*JV0 to *JV15 Manual feedrate override signals G010,G011 f f
*JV0O to *JV15O Software operators panel signals (*JV0 to *JV15) F079,F080 f f
X000#6 f f
*RILK Interlock signal for all axes
X1000#6 f f
*SP Feed hold signal G008#5 f f
*SPO Software operators panel signal (*SP) F075#7 f f
*SSTP Spindle stop signal G029#6 f
4.8
SIGNAL SUMMARY
(IN ORDER OF
FUNCTIONS)

Leave a Reply

Your email address will not be published. Required fields are marked *