Fanuc Power Mate i-D/H Maintenance Manual

5. DIGITAL SERVO
B63175EN/03
374
D TANDEM
Enter odd and even numbers for the master and slave axes for tandem
control. These numbers must be consecutive and in the range of
between 1 and 8. If a number that falls outside the valid range is
entered, the warning message INVALID FORMAT is displayed.
When soft key [SET] is pressed on the axis setting screen after data entry,
the warning message SPECIFIED DATA IS OUT OF RANGE is
displayed if any of the following conditions is satisfied.
D Both M1 and M2 are nonzero for an axis.
D Any two of TWO AXES, and TANDEM are nonzero for an axis.
D A duplicate value is specified for M1.
D A duplicate value is specified for M2.
D A duplicate value is specified for TANDEM.
D An invalid master/slave axis pair is specified for TANDEM.

Leave a Reply

Your email address will not be published. Required fields are marked *