Fanuc Power Mate i-D/H Maintenance Manual

6. AC SPINDLE (SERIAL INTERFACE)
B63175EN/03
392
The standard parameters related to each motor model can be set
automatically.
D The specifications for controlling a motor depend on the specifications
defined by the machine tool builder. The parameters defined by the
machine tool builder are set as the standard values (initial values) by
this automatic setting function.
Therefore, when performing automatic operation, always set
parameters properly according to the parameter list (parameters
4000 and later).
1. Turn on the power in the emergency stop state.
2. Set bit 7 of parameter 4019 to 1.
#7
LDSP4019
#6 #5 #4 #3 #2 #1 #0
LDSP The parameters for the serial interface spindle are:
0 : Not set automatically.
l 1 : Set automatically.
3. Set a motor model code.
4133 Motor model code
Code Motor mode Amplifier
100 b 0.5 (3000/8000min
1
) SPM2.2
101 a 1 (3000/8000min
1
) SPM2.2
102 a 1.5 (1500/8000min
1
) SPM5.5
103 a 2 (1500/8000min
1
) SPM5.5
104 a 2/1500 (3000/1500min
1
) SPM5.5
105 a 3 (1500/8000min
1
) SPM5.5
106 a 6 (1500/8000min
1
) SPM11
107 a 8 (1500/6000min
1
) SPM11
108 a 12 (1500/6000min
1
) SPM15
109 a 15 (1500/6000min
1
) SPM22
110 a 18 (1500/6000min
1
) SPM22
111 a 22 (1500/6000min
1
) SPM26
112 a P8 (750/6000min
1
) SPM11
113 a P12 (750/6000min
1
) SPM11
114 a P15 (750/6000min
1
) SPM15
115 a P18 (750/6000min
1
) SPM15
116 a P22 (750/6000min
1
) SPM22
117 a P30 (575/4500min
1
) SPM22
4. Turn off the power then back on. Then, the parameters are read.
6.1.3
Automatic Setting of
Standard Parameters

Leave a Reply

Your email address will not be published. Required fields are marked *