Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
7. TROUBLESHOOTING
419
#7
G0008
#6 #5
*SP
#4 #3 #2 #1 #0
*SP : Feed hold signal
Power Mates status display shows STRT on the CRT.
(1)Check the contents of diagnostic nos. 000 to 015.
No. Message Display
a. 000 WAITING FOR FIN SIGNAL
: 1(Example)
b. 001 MOTION : 0
c. 002 DWELL : 0
d. 003 INPOSITION CHECK : 0
e. 004 FEEDRATE OVERRIDE 0% : 0
f. 005 INTERLOCK / START LOCK : 0
g. 006 SPINDLE SPEED ARRIVAL CHECK : 0
007 WAITING FOR CHASER OPEN OR CLOSE : 0
008 DURING WAITING BY WAITING M CODE : 0
010 PUNCHING : 0
011 READING : 0
012 WAITING FOR (UN) CLAMP : 0
h. 013 JOG FEEDRATE OVERRIDE 0% : 0
i. 014 WAITING FOR RESET, ESP, RRW OFF : 0
015 EXTERNAL PROGRAM NUMBER SEARCH : 0
Items with a to i relate with an automatic operation and their details
are as follows :
An auxiliary function (M/S/T) specified in a program is not ended.
Check according to the following procedure.
At first, confirm the kind of interface of an auxiliary function.
#7
MHI3001
#6 #5 #4 #3 #2 #1 #0
MHI 0 : Auxiliary function is of normal interface.
1 : Auxiliary function is of highspeed interface.
1) Normal interface
When the auxiliary function finish signal turns from 1 to 0, the
auxiliary function is supposed to be ended and the next block is read
for operation. Confirm the status of this signal using PMCs
diagnostic function (PMCDGN).
#7
G0004
#6 #5 #4 #3
FIN
#2 #1 #0
FIN : Auxiliary function finish signal
2) Highspeed interface
The auxiliary function is supposed to be ended when the signals are
in the following state. Confirm it using PMCs diagnostic function
(PMCDGN).
2. When an automatic
operation is in progress
(Cycle start LED is lit)
a. An auxiliary function is
being executed (waiting
for FIN signal)

Leave a Reply

Your email address will not be published. Required fields are marked *