Fanuc Power Mate i-D/H Maintenance Manual

B63175EN/03
7. TROUBLESHOOTING
429
(a) Parameters on reader/puncher interface are not correct.
Check the following setting data and parameters:
<Setting>
PUNCH CODE=0 OR 1 (0: EIA,1:ISO)
Select ISO or EIA according to the type of I/O device.
If punch code does not match, alarm 86 will generate.
<Parameter>
Function
Value of parameter
0020
0 1 2
Feed 0101#7 0111#7 0121#7
Data input code 0101#3 0111#3 0121#3
Stop bit 0101#0 0111#0 0121#0
Type of I/O device 102 112 122
Baud rate 103 113 123
Communication
0135#3
method
RS232C
JD42
Connector
Channel 1 Channel 2
NOTE
Numbers in the table indicate parameters and bit numbers.
Example) 101#7:bit7 of parameter 101.
#7
NFD0101
#6 #5 #4 #3
ASI
#2 #1 #0
SB2
0111
0121
NFD 0 : Feed is output before and after data in data output (FANUC PPR)
1 : Feed is not output (standard).
ASI 0 : Data input code is EIA or ISO (automatic recognition)
1 : Data input code is ASCII.
SB2 0 : No. of stop bits is 1.
1 : No. of stop bits is 2.
Countermeasures

Leave a Reply

Your email address will not be published. Required fields are marked *