Fanuc Power Mate i-D/H Maintenance Manual

7. TROUBLESHOOTING
B63175EN/03
430
Set Value Input/output device
0 RS232C (except the following for connection with a PC)
3 FANUC Handy File
NOTE
I/O channel 2 has no control line. It can use only an I/O unit
that can be controlled using DC codes.
0103 Baud rete
0113
0123
7
8
600
1200
9 2400
10
11
12
4800
9600
19200
Value Baud rate
(b)External I/O device or Host computer is in trouble
(i) Check whether the setting on communication of external I/O
device or host computer is the same as that of the Power Mate.
(baud rate, stop bits,etc.) If they are not the same, change the
setting.
(ii)When spare I/O device presents, check whether it is possible to
realize communication using the spare I/O device.
(c) CPU card or base PC board is faulty
Replace the CPU card or base PC board.
(d)Cable between Power Mate and I/O device is faulty.
Check the cable for disconnection or wrong connection.
0102 Type of I/O device
0112
0122

Leave a Reply

Your email address will not be published. Required fields are marked *