Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
A. ALARM LIST
473
Number ContentsMessage
122 DUPLICATE MACRO MODALCALL Four nesting levels of macro calls and/or macro modal calls have been
specified.
Modify the program.
123 CAN NOT USE MACRO COMMAND
IN DNC
Macro control command is used during DNC operation.
Modify the program.
124 MISSING END STATEMENT DO END does not correspond to 1 : 1. Modify the program.
125 FORMAT ERROR IN MACRO <Formula> format is erroneous. Modify the program.
126 ILLEGAL LOOP NUMBER In DOn, 1x n x3 is not established. Modify the program.
127 NC, MACRO STATEMENT IN SAME
BLOCK
NC and custom macro commands coexist.
Modify the program.
128 ILLEGAL MACRO SEQUENCE
NUMBER
The sequence number specified in the branch command was not 0 to
9999. Or, it cannot be searched. Modify the program.
129 ILLEGAL ARGUMENT ADDRESS An address which is not allowed in <Argument Designation > is used.
Modify the program.
130 ILLEGAL AXIS OPERATION An axis control command was given by PMC to an axis controlled by
CNC. Or an axis control command was given by CNC to an axis
controlled by PMC. Modify the program.
131 TOO MANY EXTERNAL ALARM
MESSAGES
Five or more alarms have generated in external alarm message.
Consult the PMC ladder diagram to find the cause.
132 ALARM NUMBER NOT FOUND No alarm No. concerned exists in external alarm message clear.
Check the PMC ladder diagram.
133 ILLEGAL DATA IN EXT.
ALARM MSG
Small section data is erroneous in external alarm message or external
operator message. Check the PMC ladder diagram.
139 CAN NOT CHANGE PMC
CONTROL AXIS
An axis is selected in commanding by PMC axis control.
Modify the program.
145 ILLEGAL CONDITIONS IN POLAR
COORDINATE INTERPOLATION
The conditions are incorrect when the polar coordinate interpolation
starts or it is canceled.
1) In modes other than G40, G12.1/G13.1 was specified.
2) An error is found in the plane selection. Parameters No. 5460 and
No. 5461 are incorrectly specified.
Modify the value of program or parameter.
146 IMPROPER G CODE G codes which cannot be specified in the polar coordinate interpolation
mode was specified. See section II4.8 polar coordinate interpolation
and modify the program.
190 ILLEGAL AXIS SELECT In the constant surface speed control, the axis specification is wrong.
(See parameter No. 3770.) The specified axis command (P) contains an
illegal value.
Correct the program.
199 MACRO WORD UNDEFINED Undefined macro word was used. Modify the custom macro.
200 ILLEGAL S CODE COMMAND In the rigid tap, an S value is out of the range or is not specified.
The maximum value for S which can be specified in rigid tapping is set
in parameter (No.5241 to 5243). Change the setting in the
parameter or modify the program.
201 FEEDRATE NOT FOUND IN RIGID
TAP
In the rigid tapping, no F value is specified.
Correct the program.
202 POSITION LSI OVERFLOW In the rigid tapping, spindle distribution value is too large.
203 PROGRAM MISS AT RIGID
TAPPING
In the rigid tapping, position for a rigid M code (M29) or an S
command is incorrect. Modify the program.
204 ILLEGAL AXIS OPERATION In the rigid tapping, an axis movement is specified between the rigid M
code (M29) block and G84 (G74) block. Modify the program.

Leave a Reply

Your email address will not be published. Required fields are marked *