Fanuc Power Mate i-D/H Maintenance Manual

APPENDIXA. ALARM LIST
B63175EN/03
486
Number ContentsMessage
5268 NONSYNCHRO AXIS IS
COMMANDED
Synchronization was specified for an axis not related to synchroniza-
tion or for an axis with no parent (namely, topparent axis).
Check the execution program, the parent axis parameter (parameter
No. 8380), and the parent axis category parameter (parameter No.
8381).
5269 ILLEGAL APC AXIS INFORMATION APC information is being used by another function (such as the elec-
tronic cam function).
In this case, turn off the synchronization mode and check that these
settings are invalid, then turn on the synchronization mode again.
Alternatively, cancel the APC specification with the parent axis cate-
gory parameter.
14) Others
Number Message Contents Counter plan Reference
1000 to
1999
A message created by the user or
machine tool builder, using the PMC
alarm message function, is displayed.
Alarm generated by
the user or machine
tool builder using the
PMC
Apply appropriate
countermeasures as
explained in the
manual provided by
the machine tool
builder.
Manual provided by
machine tool builder
3000 to
3200
A message created by the user or
machine tool builder, using a custom
macro, is displayed.
Alarm generated by
the user or machine
tool builder, using a
custom macro
Apply appropriate
countermeasures as
explained in the
manual provided by
the machine tool
builder.
Manual provided by
machine tool builder
3000 to
3099
P/S ALARM Alarm generated by
the user or machine
tool builder, using the
PMC alarm display
function
Manual provided by
machine tool builder
Manual provided by
machine tool builder
15) Error codes at highspeed response function compile time
Number Contents
0003 A data item exceeding a maximum allowable value is entered.
0004 A block starts not with an address but with a numeric value or symbol.
0005 An address is followed not by data but by another address or an EOB code.
0006 Sign (”–”) input error (A ”–” sign is entered at an incorrect address, or two or more ”–” signs are entered.)
0007 Decimal point input error (The decimal point must not be used.)
0009 An unusable address is entered in a significant information section.
0010 An unusable G code is specified.
0011 The cutting feedrate is incorrect.
Probable causes are as follows:
(1) No feedrate was specified.
(2) A feedrate of 0 was specified.
0015 An attempt was made to make movements on axes more than the number of simultaneously controlled axes
in one block.
0053 A comma (,) is input. (A comma (,) is unusable.)
0070 The size of memory is insufficient.
0113 # is entered. (# can be used only to specify a travel distance and feedrate.)
0114 A macro statement is entered. (No macro statement may be used.)
0115 An incorrect variable number is used.
1000 A slash (/) is used. (No slash (/) may be used.)

Leave a Reply

Your email address will not be published. Required fields are marked *