Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
A. ALARM LIST
487
Number Contents
1001 G codes of group 00 and group 01 are specified in the same block.
1002 The number of words in a block exceeded the maximum allowable number of words.
1010 In a G31 block, no axis is specified, or two or more axes are specified.
1011 In a G31 block, an unusable P code is used.
1020 In an M code block, a G code is specified.
1021 In an M code block, an axis is specified.
1022 An unusable M code is specified.
1024 In an M code block, an incorrect P code is specified.
1025 In an M code block, no P code is specified.
1027 In an M code block, feedrate F is specified.
1040 In a continuous feed block, no axis is specified, or two or more axes are specified.
1091 In a block where optional block skip is specified, feedrate F is specified.
1094 In a block where optional block skip is specified, a G code of group 01 is specified.
1096 In a block where optional block skip is specified, a G code of group 03 is specified.
1100 The program includes no axis command.
1101 There is no program to be compiled (O8000 to O8031).
1102 With the signalbased compilation function, a program number unusable for a motion program is specified.
1800 A motion program is being executed.
1821 A compilation operation was performed in the reset state.
1822 A compilation operation was performed when an alarm was issued.
1823 A compilation operation was performed during NC program execution.
1824 The programs having numbers O8000 to O8999 must not be edited.
1825 The program area is protected by the memory protection key.
1826 Background editing is being performed.

Leave a Reply

Your email address will not be published. Required fields are marked *