Fanuc Power Mate i-D/H Maintenance Manual

APPENDIXC. BOOT SYSTEM
B63175EN/03
510
3 To start loading, press the [YES] soft key. To cancel, press the [NO]
key.
*** MESSAGE ***
LOADING FROM MEMORY CARD.
4 When loading terminates normally, the system displays the following
message. Press the [SELECT] soft key. If an error occurs, see C.3
*** MESSAGE ***
LOADING COMPELETE. HIT SELECT KEY.
Selecting SYSTEM DATA LOADING displays the file selection screen,
shown below. Pressing the [] or [] key on the DPL displays the names
of the files in the memory card. Once the name of the file to be loaded
appears, pressing the [INPUT] key starts loading of that file.
LOADING MENU
*88F1A.MEM
: File selection screen
During loading, the following screen is displayed:
88F1A.MEM
LOADING
: The name of the file being loaded is dis-
played and LOADING blinks.
Once loading has been completed, the file selection screen is displayed
again.
To end the operation, press the [INPUT] key once *END appears on the
screen. The initial screen is displayed. Pressing the [CAN] key also
causes the initial screen to be displayed.
1 Counter display while a file is being loaded (CRT, etc.)
While a file is being loaded, the address of the data currently being
accessed is displayed.
*** MESSAGE ***
LOADING FROM MEMORY CARD.
ADDRESS 001:
² The counter appears under the
message fild.
(1)
(1): Number of 128KB management unit in FROM
2 File name in FROM
The boot system identifies a file in FROM by the first four characters
of the file name. If FROM has a file of the same type as a file to be
read from the memory card, the file in FROM is deleted before the file
on the memory card is read. The following table lists the file names
and the contents. Note that these file names are subject to change
without prior notice.
D Screen configuration and
operation (DPL/MDI)
D Others

Leave a Reply

Your email address will not be published. Required fields are marked *