Fanuc Power Mate i-D/H Maintenance Manual

APPENDIXC. BOOT SYSTEM
B63175EN/03
512
1 Select the file whose details are required. For example, select 1 NC
BASIC (10).
2 The numbers of management units in the selected file are listed,
together with the series and edition of the software in each
management unit. After checking the listed data, select the
[SELECT] soft key to return to the file selection screen.
ROM FILE CHECK
NC BASIC
0 88E0 801A 000
1 88E0 802A 001
2 88E0 841A 002
3 88E0 842A 003
4 88E0 881A 004
5 88E0 882A 005
6 88E0 8C1A 006
7 88E0 8C2A 007
*** MESSAGE ***
CONTINUE. HIT SELECT KEY.
[ SELECT ][ YES ][ NO ][ UP ][ DOWN ]
Internal managementunit
number
ROM number and edition
Series
0 88E0 801A 000
Selecting SYSTEM DATA CHECK displays the file information screen,
shown below. Pressing the [] or [] key on the DPL displays other file
information.
CHECK MENU
1 NC BASIC(10)
: File information screen
The number of control units used by the file
(1 unit = 128 KB) is indicated in paren-
theses.
When a file name is displayed, pressing the [INPUT] key displays
detailed information for that file, including the series, ROM number,
edition, and internal control number (up to 16).
NC BASIC
1 88F1 801A 00
: File detailed information screen
To end the operation, press the [INPUT] key once *END appears on the
screen. The file information screen is displayed. Pressing the [CAN] key
also displays the file information screen.
To return from the file information screen to the initial screen, press the
[INPUT] key once *END appears on the screen. The initial screen is
displayed. Pressing the [CAN] key also displays the initial screen.
Parity information for the system file and user file
The NC BASIC, DG SERVO, and other system files in FROM contain
parity information in each management unit. If the file name field or
parity field on the check screen contains a nonASC II character or an
@ , the FROM may have been destroyed or a damaged file may have
been read. Reread the data from the memory card.
The PMCRB, PCD 0.5M, and other user files do not contain parity
information in each management unit. A nonASCII character or an @
may appear in the series/edition information. In this case, it does not
indicate that the file has been damaged.
D Screen configuration and
operating procedure
(DPL/MDI)
D Operation (DPL/MDI)
D Others

Leave a Reply

Your email address will not be published. Required fields are marked *