Fanuc Power Mate i-D/H Maintenance Manual

APPENDIXC. BOOT SYSTEM
B63175EN/03
514
Selecting SYSTEM DATA DELETE displays the file selection screen,
shown below. Pressing the [] or [] key on the DPL displays the names
of the files in flash memory. Once the name of the file to be deleted
appears, pressing the [INPUT] key deletes that file.
DELETE MENU
1 PD1M256K(2)
: File selection screen
The number of control units used by the file
(1 unit = 128 KB) is indicated in paren-
theses.
During deletion, the following screen is displayed:
PD1M256K
DELETE
: The name of the file being deleted is
displayed and DELETE blinks.
Once deletion has been completed, the file selection screen is displayed
again.
To end the operation, press the [INPUT] key once *END appears on the
screen. The initial screen is displayed. Pressing the [CAN] key also
displays the initial screen.
System files and user files on SYSTEM DATA DELETE screen
The system files are protected from accidental deletion. User files,
however, are not protected. Protected system files can be overwritten
from the SYSTEM DATA LOADING screen.
This screen is used to write a user file in FROM to a memory card. Only
user files can be saved from FROM to a memory card. System files cannot
be saved.
SYSTEM DATA SAVE
FILE DIRECTORY (FLASH ROM : 4MB)
1 NC BASIC ( 10)
2 DG SERVO ( 1)
3 PMC0BSC ( 2)
4 PMCRB ( 1)
5 PCD 0.5M ( 4)
END
*** MESSAGE ***
SELECT FILE AND HIT SELECT KEY.
[ SELECT ][ YES ][ NO ][ UP ][ DOWN ]
(1)
(2)
(3)
(4)
(1) : Screen title
(2) : Names of files in FROM The number of management units
constituting each file appears in parentheses to the right of the file
name.
D Operation (DPL/MDI)
D Others
C.2.4
SYSTEM DATA SAVE
Screen
D Description
D Screen configuration
(CRT/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *