Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
C. BOOT SYSTEM
515
(3) : Returning to the previous menu
(4) : Message
1 Position the cursor to the name of the file to be deleted. Press the
[SELECT] soft key.
2 The system displays the following confirmation message :
*** MESSAGE ***
SAVE OK ? HIT YES OR NO.
3 To start saving, press the [YES] key. To cancel, press [NO].
*** MESSAGE ***
WRITING FLASH ROM FILE TO MEMORY CARD.
SAVE FILE NAME : PMC_SB.000
4 When saving terminates normally, the system displays the following
message. Press the [SELECT] key. The names of files written to the
memory card are listed. Check the file names by, for example, making
a note of the list.
*** MESSAGE ***
FILE SAVE COMPELETE. HIT SELECT KEY.
SAVE FILE NAME : PMC_SB.000
Selecting SYSTEM DATA SAVE displays the file selection screen,
shown below.
Pressing the [] or [] key on the DPL displays the names of the files in
flash memory. Once the name of the file to be saved appears, pressing the
[INPUT] key saves
SAVE MENU
3 PMC RB(1)
: File selection screen
The number of control units used by the file
(1 unit = 128 KB) is indicated in paren-
theses.
During saving, the following screen is displayed:
PMC RB.000
SAVE
: The name of the file being saved is
displayed and SAVE blinks.
Once saving has been completed, the file selection screen is displayed
again.
To end the operation, press the [INPUT] key once *END appears on the
screen. The initial screen is displayed. Pressing the [CAN] key also
displays the initial screen.
1 System files and user files on SYSTEM DATA SAVE screen
The SYSTEM DATA SAVE function provides a safeguard against free
copying of the system files.
User files, however, are not protected.
D Screen configuration and
operating procedure
(DPL/MDI)
D Operation (DPL/MDI)
D Others

Leave a Reply

Your email address will not be published. Required fields are marked *