Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
C. BOOT SYSTEM
517
(3) : Returning to the previous menu
(4) : Size of SRAM memory on the Power Mate i
(5) : File name
(6) : Message
1 Select 1. SRAM BACKUP. The following confirmation message is
displayed. The file name may be displayed according to the SRAM
capacity.
2 Pressing [YES] triggers a batch backup.
*** MESSAGE ***
BACKUP SRAM DATA OK ? HIT YES OR NO.
3 If a same file name is already on the memory card, you will be
prompted to confirm whether to permit overwriting.
4 The name of the file being written to the memory card is displayed in
the FILE NAME: field.
SRAM SIZE : 0.5MB (BASIC)
FILE NAME : SRAM0_5A.FDB ³ MEMORY CARD
*** MESSAGE ***
SRAM DATA WRITING TO MEMORY CARD.
Name of the file being
saved
5 Upon terminating normally, the system displays the following
message. Press the [SELECT] soft key.
*** MESSAGE ***
SRAM BACKUP COMPLETE. HIT SELECT KEY.
1 Select 2. RESTORE SRAM. The system displays the following
message. Press the [YES] key.
*** MESSAGE ***
RESTORE SRAM DATA OK ? HIT YES OR NO.
2 The system displays the following message during restoration.
*** MESSAGE ***
RESTORE SRAM DATA FROM MEMORY CARD.
D Operating procedure
[For batch backup]
[Restoring the data]

Leave a Reply

Your email address will not be published. Required fields are marked *