Fanuc Power Mate i-D/H Maintenance Manual

APPENDIXC. BOOT SYSTEM
B63175EN/03
518
3 Upon terminating normally, the system displays the following
message. Press the [SELECT] soft key.
*** MESSAGE ***
RESTORE COMPLETE. HIT SELECT KEY.
Selecting FILE DATA BACKUP/RESTORE displays the selection
screen, shown below. Select BACKUP or RESTORE by pressing the []
or [] key. Then, pressing the [INPUT] key saves or restores the file data.
BACKUP : Save data into the backup file.
RESTORE : Restore data from the backup file.
FILEDATA MENU
1. FILE BACKUP
: The file data is saved into the memory
card.
During saving or restoration, the following screen is displayed:
SRAM256A.FDB
BACKUP
: The name of the file being saved or
restored is displayed and BACKUP blinks.
Once saving or restoration has been completed, the selection screen is
displayed again. To end the operation, press the [INPUT] key once *END
appears on the screen. The initial screen is displayed. Pressing the [CAN]
key also displays the initial screen.
1 Name of backup file
The name of the backup file written to the memory card by the SRAM
backup function depends on the size of the SRAM installed in the
Power Mate i.
When the size of SRAM is 1MB or larger, backup files are created in
units of 512 KB.
Number of files 1 2
SRAM size
256KB SRAM256A.FDB
1.0MB SRAM1_0A.FDB SRAM1_0B.FDB
CAUTION
In a system using an absolute pulse coder, using this
function to restore parameters causes the zero point setup
flag (bit 4 of parameter 1815) to be cleared, so it becomes
necessary to reset up the reference point.
D Screen configuration and
operation procedure
(DPL/MDI)
D Others

Leave a Reply

Your email address will not be published. Required fields are marked *