Fanuc Power Mate i-D/H Maintenance Manual

APPENDIX
B63175EN/03
C. BOOT SYSTEM
521
Selecting MEMORY CARD FORMAT displays the confirmation screen,
shown below. Pressing the [INPUT] key starts formatting. To cancel
formatting, press the [CAN] key. The initial screen is displayed again.
CARD FORMAT OK?
PUSH INP OR CAN.
: Confirmation screen PUSH INP OR CAN.
blinks.
During formatting, the following screen is displayed:
CARD FORMAT
EXEC
: EXEC blinks.
Once formatting has been completed, the initial screen is displayed again.
The function is used to terminate the boot system and activate the Power
Mate i.
From the MAIN MENU screen, select 9. END. The system displays
the ARE YOU SURE? HIT YES OR NO message. To terminate the
boot system and activate the CNC, press the [YES] soft key. Press the
[NO] soft key, and you will be brought back to the main menu.
*** MESSAGE ***
ARE YOU SURE ? HIT YES OR NO.
[ SELECT ][ YES ][ NO ][ UP ][ DOWN ]
1 After pressing the [YES] soft key
The system checks the NC BASIC system file in the flash ROM. The
system displays the following message :
*** MESSAGE ***
CHECK CNC BASIC SYSTEM.
[ SELECT ][ YES ][ NO ][ UP ][ DOWN ]
When the NC BASIC system file is found to be normal, the system
sends the system file to DRAM and starts the NC basic system. During
loading, the system blinks the following message.
*** MESSAGE ***
LOADING BASIC TO DRAM
[ SELECT ][ YES ][ NO ][ UP ][ DOWN ]
If the NC BASIC SYSTEM content has been disrupted, the error
message ROM PARITY ERROR: NC BASIC. HIT SELECT.
appears.
D Operation (DPL/MDI)
C.2.8
LOAD BASIC SYSTEM
Function
D Description
D Operating procedure
(CRT/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *