Fanuc Power Mate i-D/H Maintenance Manual

APPENDIXC. BOOT SYSTEM
B63175EN/03
522
2 If the [NO] soft key is pressed, the system returns to the processing
selection state as shown below :
*** MESSAGE ***
SELECT MENU AND HIT [SELECT] KEY.
[ SELECT ][ YES ][ NO ][ UP ][ DOWN ]
Selecting SYSTEM MONITOR EXIT displays the confirmation screen,
shown below. Pressing the [INPUT] key loads the basic system from
flash memory into DRAM. To cancel loading, press the [CAN] key. The
initial screen is displayed again.
MONITOR EXIT
PUSH INP OR CAN.
: Confirmation screen PUSH INP OR CAN.
blinks.
During loading, the following screens are displayed, in the order shown:
CHECK CNC BASIC
SYSTEM.
CHECK CNC BASIC
TO DRAM.
CHECK CNC BASIC
LOADED.
Once loading has been completed, the series and edition are displayed and
starting.
D Operation (DPL/MDI)

Leave a Reply

Your email address will not be published. Required fields are marked *